Too Many Message Boards › General Topics › General Discussion v
The end has been delayed

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
The end has been delayed
harm_less Offline
Common or garden moderator
*****
Posts: 968
Threads: 45
Joined: Feb 2020
Reputation: 49
Staff
#12
24-02-2020, 08:22 PM
(24-02-2020, 03:58 PM)s.monkey Wrote: "Complications behind the scenes". If I had to guess I'd say that because the messageboard software is very outdated it's a big job to modify it.
It does have that 'nailed together' look about it compared to this place Confused
www.HarmLessSolutions.co.nz

Thread: The end has been delayed
Find
Reply


Messages In This Thread
The end has been delayed - by Praktica - 24-02-2020, 03:54 PM
RE: The end has been delayed - by Oh_hunnihunni - 24-02-2020, 03:56 PM
RE: The end has been delayed - by videomonkey - 24-02-2020, 03:58 PM
RE: The end has been delayed - by Praktica - 24-02-2020, 04:11 PM
RE: The end has been delayed - by insain - 24-02-2020, 06:05 PM
RE: The end has been delayed - by Admin - 24-02-2020, 07:31 PM
RE: The end has been delayed - by videomonkey - 24-02-2020, 07:41 PM
RE: The end has been delayed - by harm_less - 24-02-2020, 08:22 PM
RE: The end has been delayed - by Oh_hunnihunni - 24-02-2020, 03:59 PM
RE: The end has been delayed - by Gammy - 24-02-2020, 06:19 PM
RE: The end has been delayed - by videomonkey - 24-02-2020, 07:19 PM
RE: The end has been delayed - by nzoomed - 24-02-2020, 07:53 PM
RE: The end has been delayed - by Praktica - 24-02-2020, 08:52 PM
RE: The end has been delayed - by crafters_corner - 24-02-2020, 09:40 PM
RE: The end has been delayed - by videomonkey - 24-02-2020, 09:42 PM
RE: The end has been delayed - by crafters_corner - 25-02-2020, 10:38 AM
RE: The end has been delayed - by crab2 - 25-02-2020, 10:46 AM
RE: The end has been delayed - by Admin - 24-02-2020, 09:46 PM
RE: The end has been delayed - by olwen - 25-02-2020, 08:09 AM
RE: The end has been delayed - by Oh_hunnihunni - 25-02-2020, 08:44 AM

Forum Jump:


Users browsing this thread: 15 Guest(s)